| DTC Strategy |
- HO2S output value inspection under certain conditions
|
- Poor Connector Connection
- HO2S
- Filter clogging of the fuel pump
- ECM
|
| Enable Conditions |
- Fuel cut function disabled state
- Not the maximum load state
- Catalytic over-heating prevention inactive state
- Battery voltage higher than 11V and lower than 16V
|
| Threshold Value |
- Target lambda value is 0.8 (rich), HO2S (down) voltage lower than 0.75V (after P2096 detected)
|
| Diagnostic Time |
- 7s after the target value of lambda is moved to the rich)
|
| MIL ON Condition |
|