LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Forte LX, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Control System - 2.0L GDI) >> Injector >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do not reuse the used injector fixing clip.
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
  • Do not reuse the used bolt.
  • When inserting the injector, be careful not to damage the injector tip.
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.
  • Do not reuse the combustion seal.
    Fig 1: Locating Steal Plate And Rubber Plate
    G12162492Courtesy of KIA MOTORS AMERICA, INC.
  1. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals