LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Forte5 EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Driveshaft Assembly) >> BJ Boot >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front driveshaft.

    (Refer to Driveshaft Assembly - "FRONT DRIVESHAFT ")

  2. Remove the TJ joint assembly.

    (Refer to Driveshaft Assembly - "TJ JOINT ")

  3. Remove the Dynamic damper.

    (Refer to Driveshaft Assembly - "DYNAMIC DAMPER ")

  4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
    Fig 1: Removing BJ Boot Bands
    G12329315Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the BJ boot.
  6. Install in the reverse order of removal.
    CAUTION:
    • Do not disassemble the BJ assembly.
    • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
    • The boot band should be replaced with a new one.
  7. Check the front alignment.

    (Refer to Suspension System - "ALIGNMENT ")

scientia non olet · About LEMON Manuals