Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

Connect KDS/GDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
Clear all DTCs in the system with GDS/KDS.
Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS and verify that any DTC is stored.
Verify that the DTC is cleared and system operates correctly.

Good	Problem is corrected and the system operation performs to specification at this time.
No Good	Go to applicable troubleshooting DTC INDEX procedure.