LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Rio LX, 4D Sedan, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System >> Knock Sensor (KS) >> Repair Procedures >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold (Refer to "INTAKE AND EXHAUST SYSTEM ").
  3. Disconnect the connector (A).
  4. Remove the installation bolt (B), and then remove the sensor from the cylinder block.
Fig 1: Locating Connector And Bolt
G11845156Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals