LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Sorento L >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System/Electronic Stability Control Diagnosis >> DTC C1605-08: CAN Hardware Error >> Component Inspection >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection: Notes

  1. Ignition switch "OFF"
  2. Connect GDS to Data Link Connector (DLC).
  3. Ignition switch "ON"
  4. Monitor "Diagnostic Trouble Codes (DTC)  " with GDS.
  5. Clear any DTCs stored in the system with GDS.
  6. Re-check DTC in the system with GDS.
  7. Did the same DTC is stored in the system?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals