Repair Procedures: Installation
WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.
- Install the curtain airbag and then loosen the bolts and nuts.
Tightening Torque
7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
CAUTION: Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally. - Connect the curtain airbag connector.
- Install the roof trim.
(Refer to Body (Interior and Exterior) - "ROOF TRIM ASSEMBLY ")
- Reconnect the battery negative terminal.
- After installing the curtain airbag (CAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
NOTE:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off