Basic Inspection

WARNING: Hybrid battery system uses high voltage.
It may cause death or damage due to electrical shock, if you do not follow below Instructions.

Follows instructions of Appropriate Service Information.
Wear and use insulated gloves and tools.
Ignition "OFF", Disconnect ground cable of auxiliary battery and "OFF" the safety connector of the high voltage battery.
Check high voltage terminal on Power Relay Assembly is lower than 30V.
Be careful that it should not be short between terminals when measuring battery cell voltage. You may be injured due to spark, parts damage or electrical shock.
Metallic material cause high voltage short that may cause damage of life or vehicle. Therefore, get rid of all the metallic material before working. (Metallic Material: Watch, Ring, any metallic products etc.)
After disconnect W/H goes to ECUs from High voltage battery, be careful not to happen short between exposed terminal and terminal on high voltage connector.

Inspection Procedure

Check fuses and relays.
Check battery terminals and charge status.
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Good

No Good