Verification Of Repair
After a repair, it is essential to verify that the fault has been corrected.
- Connect KDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
- Clear all DTCs in the system with KDS.
- Operate system of vehicle within DTC detecting condition in DTC Detecting Condition chart.
- Monitor "Diagnostic Trouble Codes (DTC)" with KDS and verify that any DTCs are stored.
- Verify that the DTC is cleared and system operates correctly.
| Good | Problem is corrected and the system operation performs to specification at this time. |
| No Good | Go to applicable troubleshooting procedure. |