ECM Neutral Mode Procedure (With Immobilizer)

WARNING: This page is about a different variant/trim than selected.

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.

[If installing a used ECM]

Perform "ECM Neutral Mode" procedure using KDS/GDS.
(Refer to " Repair Procedures ")
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS/GDS.
(Refer to " Repair Procedures ")

[If installing a new ECM]

Perform "Key Teaching" procedure using KDS/GDS.

(Refer to " Repair Procedures ")