Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Release the residual pressure in fuel line.
(Refer to " RELEASE RESIDUAL PRESSURE IN FUEL LINE ").
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
Remove the intake manifold.
(Refer to " INTAKE MANIFOLD ")
Remove the injector foam (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Rail Pressure Sensor:

30.0 - 34.3 N.m (3.0 - 3.5 kgf.m, 22.1 - 25.3 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.