ECM Neutral Mode procedure (With Immobilizer)

WARNING: This page is about a different variant/trim than selected.

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]

Perform "ECM NEUTRAL MODE " procedure using KDS.
(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using KDS.
(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")

[If installing a new ECM]

Perform "Key Teaching" procedure using KDS.

(Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")