Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of KIA MOTORS AMERICA, INC.

NOTE:

Do not reuse the used injector fixing clip.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply engine oil to the injector O-ring.
Do not reuse the used injector O-ring.
Do not reuse the used bolt.
When inserting the injector, be careful not to damage the injector tip.
Do not reuse the high pressure fuel pipe.

NOTE:

Do not reuse the support disc.
Do not reuse the injector rubber washer.
When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.

Courtesy of KIA MOTORS AMERICA, INC.

NOTE:

NOTE:

When tightening the delivery pipe installation bolts, tighten them in accordance with the order ((2)→(3)→(1)→(4)) after tightening with hand screwed torque.

Fig 1: Delivery Pipe Installation Bolts Tightening Sequence (2, 3, 1, Then 4)

Courtesy of KIA MOTORS AMERICA, INC.