LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2019 >> Sedona LX >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) System >> Yaw-Rate & G Sensor >> Repair Procedures >> Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation: Notes

  1. Remove the ignition key from the vehicle.
  2. Install in the reverse order of removal.
  3. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    • SRSCM senses the vehicle rollover. SAB, CAB and BPT may be deployed if SRSCM was shaken up and down or left and right during IGN ON state.

      For this reason, make sure that the IGN is turned OFF before removing the SRSCM from the vehicle.

    • Whenever the SRSCM is replaced, perform variant coding. Also, perform the lateral G sensor calibration.

      (Refer to Restraint - "SRS CONTROL MODULE ")

scientia non olet · About LEMON Manuals