Verification Of Repair

After a repair, it is essential to verifying that the fault has been corrected.

1. Connect KDS/GDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)  ".
2. Clear all DTCs in the system with KDS/GDS.
3. Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
4. Monitor "Diagnostic Trouble Codes (DTC)  " with KDS/GDS and verify that any DTC is stored.
5. Are any DTCs stored in the system?

   YES 

   • Go to applicable troubleshooting procedure.

   NO 

   • Problem is corrected and the system operation performs to specification at this time.