Repair Procedures: Replacement

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.

Loosen the Front Seat Mounting Bolts (A).
Tightening Torque:

44.1 - 58.8 N.m (4.5 - 6.0 kgf.m, 32.5 - 43.4 lb ft)

[Front]

Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the airbag connector (A), seat warmer & power seat switch connector (B), front seat belt buckle connector (C), heater seat unit connector (D).
[Driver's]

Courtesy of HYUNDAI MOTOR AMERICA

[Passenger's]

Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information

SEAT MOUNTING BOLT INSTALLATION PROCEDURE
- Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into the foremost position. Check that each slide is locked, and then tighten the rear mounting bolt completely.
- Set the seat into the rearmost position. Check that the front mounting bolt is tightened completely.
- Check that the seat operates to and fro smoothy and the locking portion locks properly.