Repair Procedures: Disassembly
WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the engine room under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Remove the front wheel guard.
(Refer to Body - "FRONT WHEEL GUARD ")
- Loosen the drive belt.
(Refer to Engine Mechanical System - "DRIVE BELT ")
- Remove the clutch bolt while holding the pulley with a clutch bolt remover (09977-29000).
Tightening Torque:
10.0 - 15.0 N.m (1.02 - 1.53 kgf.m, 7.37 - 11.0 lb-ft)
- Loosen the limiter bolts and then remove the limiter & hub assembly (A).
- Remove the pulley (B) after removing the snap ring (A) with a snap ring plier.NOTE:
- Be careful not to damage the pulley and compressor during disassembly / reassembly.
- Once the snap ring is removed, replace it with a new one.
- Reassemble in the reverse order of disassembly.NOTE:
- Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
- Install a new snap ring, and make sure they are fully seated in the groove.
- Make sure that the pulley turns smoothly after reassembly.