| Noise/rattle |
1. Noise generated near the MDPS column & housing.
- Remove the surrounding parts and check whether the same noise occurs.
|
- Replace the partial component of the column and housing
- Replace the motor if the noise occurs
|
| Noise/rattle |
1. Check the handle and surrounding fastening parts.
- Check DAB wiring arrangement, DAB, clock spring, multi-function switch, etc.
|
Check the noise of the relevant part
- Perform a separate inspection.
|
2. Check where the C-MDPS is installed.
- Loosen the cowl fastening bolt and reassemble. (including the through bolt fixing the lower part of the C-MDPS)
|
Check the installation of the cowl |
3. Check the fastening area of the universal joint bolt.
- Completely remove the universal joint and check whether the noise occurs after the reinstallation.
|
Fasten with a new bolt if the universal joint bolt is worn |
4. Check free playing area of the column when steering while the vehicle is stopped.
- Check the main wiring connected to the MDPS and column/interference around the shroud/friction
|
Keep spaces between the surrounding parts
- Check freeplay around the wiring and column and inspect interference.
|