Repair Procedures: Removal: Notes
NOTE:
In case of replacing the controller (ECU) and transfer case due to changing characteristics of the frictional materials inside the transfer case, it is necessary to check and enter the calibration data.
- In case of replacing the transfer case assembly only, perform the clutch learning reset in the using KDS equipment.
(Refer to 4 Wheel Drive (AWD) system - "REPAIR PROCEDURES ")
- In case of replacing the ECU only, perform the clutch learning back-up and writing in the new transfer case ECU using KDS equipment.
(Refer to 4 Wheel Drive (AWD) system - "REPAIR PROCEDURES ")
- In case of replacing the ECU and transfer case assembly, perform the clutch learning back-up and writing in the new transfer case ECU using KDS equipment.
(Refer to 4 Wheel Drive (AWD) system - "REPAIR PROCEDURES ")
NOTE:
Cautions in handling the transfer case
- Preventing the oil leaking
- Even with the ventil valve installed, oil leaks from the collected oil during disassembling/assembling procedures in case of failure of keeping the horizontal position. Therefore, use caution when replacing the transmission.