Signal Circuit Inspection
- Ignition "OFF"
- Refer to "FUEL TANK PRESSURE SENSOR (FTPS) " and disconnect Fuel Tank Pressure Sensor (FTPS) connector.
- Ignition "ON"
- Measure voltage between Pin No. 3 (Signal) terminal of Fuel Tank Pressure Sensor (FTPS) harness connector and chassis ground.
Specification: Approx. 0V
- Ignition "OFF"
- Disconnect Battery (-) terminal.
- Refer to "FUEL TANK PRESSURE SENSOR (FTPS) " and disconnect Fuel Tank Pressure Sensor (FTPS) connector.
- Measure resistance between Pin No. 3 (Signal) terminal of Fuel Tank Pressure Sensor (FTPS) harness connector and chassis ground.
Specification: ∞ (infinite)Ω
- Is measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open or short in signal circuit of Fuel Tank Pressure Sensor(FTPS) and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.