Repair Procedures: Installation
WARNING: This page is about a different car, the 2020 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be sure to install the harness wires so they will not pinch or interfere with other parts.
NOTE:
- Do Not open the lid of the side airbag cover.
- Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
- Remove the Ignition Key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes.
- Place a side airbag on the side airbag (A) frame and tighten the side airbag mounting nuts.
- Install the front seat back cover.
(Refer to Body - "FRONT SEAT BACK COVER ")
- Install the front seat assembly.
(Refer to Body - "FRONT SEAT ASSEMBLY ")
- Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
- Reconnect the Battery Negative Cable.
- After installing the side airbag (SAB), confirm proper system operation:
- Turn the Ignition Switch ON; the SRS indicator light should be turned on for about six seconds and then go OFF.