April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Ignition "OFF". Ignition "ON". Connect KDS/GDS/GDS to Data Link Connector (DLC). Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS. Clear any DTCs stored in the system with KDS/GDS. Operate the vehicle or system according to the diagnostic conditions of the failure condition. Re-check DTC in the system with KDS/GDS. Has the fault code been expressed?	-

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SCC/FCA module and then go to "VERIFICATION OF REPAIR " procedure.