Repair Procedures: Replacement

WARNING: This page is about a different car, the 2024 Kia K5. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to prevent hand injuries.

Remove the gear knob and boots (A) by pulling it upwards.

Courtesy of KIA MOTORS AMERICA, INC.

Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the console upper garnish (A).

Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the console upper cover (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connectors (A).

Courtesy of KIA MOTORS AMERICA, INC.
Using a screwdriver or remover, remove the console tray (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the console side cover (A).
[LH]

Courtesy of KIA MOTORS AMERICA, INC.

[RH]

Courtesy of KIA MOTORS AMERICA, INC.
Remove the storage box pad (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the console main connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting screws and bolts, remove the floor console assembly (A).
Tightening torque:

6.9 - 9.8 N.m (0.7 - 1.0 kgf.m, 5.0 - 7.2 lb.ft, 60.8 - 86.8 lb.in)

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damaged clips (or pin-type retainers).