Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.

NOTE:

The existing valve body cover gasket (A) must be replaced with a new one (do not reuse).

Courtesy of KIA MOTORS AMERICA, INC.

Perform the procedures below after installing.
1. Refill the automatic transaxle with fluid.
  (Refer to Hydraulic System - "FLUID ")
2. Refill the engine & transaxle system with coolant.
  (Refer to Engine Mechanical System - "COOLANT ")
3. Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the KDS.
  (Refer to Hybrid Motor System - "COOLANT ")
Confirm that there is no fluid leakage on connections in the engine starting condition.