Inspection Procedure

Check the fuel line

1. Check following item at high pressure fuel line visually.
   • Connector connection state.
   • Damage/connection state for vacuum hoses connected to fuel line.
   • Bent/pressed/twisted fuel line or fuel leakage.

Check fuel pressure

1. Ignition "OFF". Disconnect fuel pump fuse in junction box.
2. Start the engine and wait until it stalls.
3. Ignition "OFF". Connect fuel pump fuse.
4. Install the fuel pressure gauge to the delivery pipe using the fuel pressure gauge adaptor.
5. Activate the fuel pump, check for fuel leaks from the pressure gauge or fuel system.
6. Measure the fuel pressure at idle.
   • Specification:  Over 290 kPa (2.9 bar, 2.95 kgf/cm² )

   Good 

   • Go to "WIRING INSPECTION " procedure.

   No Good 

   • Repair as necessary and Go to "VERIFICATION OF REPAIR " procedure.