Road Test
WARNING:
The use of cruise control is not recommended on winding, snow covered or slippery roads or in heavy traffic conditions where a constant speed cannot be maintained.
CAUTION:
Do not engage cruise control when vehicle is being used in low transfer gears.
- Start engine and depress main control switch to actuate cruise control system. Accelerate to approximately 30 mph (50 km/h) and operate SET/ACC switch, immediately release switch, remove foot from accelerator pedal, vehicle should maintain speed at which SET/ACC switch was operated.
- Operate SET/ACC switch and hold at that position, vehicle should accelerate smoothly until switch is released. The vehicle should now maintain new speed at which SET/ACC switch was released.
- Apply RES/DECEL switch while vehicle is in cruise control mode, cruise control should disengage. Slow to approximately 35 mph (55 km/h), operate RES/DECEL switch, immediately release switch and remove foot from accelerator vehicle should smoothly accelerate to previously set speed. Increase speed using accelerator pedal and release pedal, vehicle should return to previously set speed.
- Operate brake pedal, cruise control system should immediately disengage returning vehicle to driver control at accelerator pedal. Operate RES/DECEL switch, vehicle should accelerate to previously memorized set speed without driver operation of accelerator pedal.
- Operate RES/DECEL switch and allow vehicle to decelerate to below 26 mph (42 km/h). Operate RES/DECEL switch, cruise control system should remain disengaged.
- Operate SET/ACC switch below 28 mph (45 km/h), cruise control system should remain disengaged. Accelerate, using accelerator pedal to above 28 mph (45 km/h), operate RES/DECEL switch, and remove foot from accelerator pedal, vehicle should smoothly adjust to previously memorized speed.
- Depress main control switch in auxiliary switch panel, cruise control system should immediately disengage and erase previously set speed from ECU memory.