Built-In Test Procedure

1. Starting conditions: ignition off, doors unlocked, hood switch depressed.
2. Carry out instructions  3 to  7 within 8 seconds.
3. Release hood switch.
4. Switch ignition ON.
5. Lock doors.
6. Switch ignition OFF.
7. Switch ignition ON.

If alarm is correctly accessed, horn will sound and LED will flash. The following checks can be made.

1. Open and close any door or tailgate and LED will light.
2. Depress hood switch and hazard lights will flash.
3. Check engine cranking is disabled. Do not turn off ignition.
4. Check ultrasonic by operating handset, LED will emit one 5 second flash, and will flash if interior is disturbed.
NOTE: If ECU is in new born mode any handset of the right frequency will work. If not an initialized handset is required see HANDSET INITIALIZATION  under PROGRAMMING.
5. Turn OFF ignition or press handset to end test procedure. Horn will sound as before to indicate end of test mode.