Section 15 (Engine Controls - Basic Diagnostic Procedures): Introduction
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 Land Rover Freelander, 2004 Land Rover Discovery, 2003 Land Rover Freelander, 2003 Land Rover Discovery, and 2002 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
The following diagnostic steps will help prevent overlooking a simple problem. This is also where to begin diagnosis for a no-start condition.
The first step in diagnosing any driveability problem is verifying the customer's complaint with a test drive (if possible) under the conditions the problem reportedly occurred.
Before entering self-diagnostics, perform a careful and complete visual inspection. Most engine control problems result from mechanical breakdowns, poor electrical connections or damaged/misrouted vacuum hoses. Before condemning the computerized system, perform each test listed in this article.
NOTE:
Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure.