Navigation System Traffic Module: Installation
WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Install the navigation system traffic module.
- Tighten the 2 nuts to 10 Nm (7 lb.ft).
- Connect the navigation system module optical connector.
- Connect the navigation system traffic module coaxial cable connector.
- Connect the navigation system traffic module electrical connector.
- Install the access panel to the loadspace trim panel LH.
- Connect the battery ground cable. Refer to Specifications .
- Using the Land Rover approved diagnostic system, follow the on-screen instructions and configure the navigation system traffic module.