Programmed Defrost
WARNING: This page is about a different car, the 2006 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
The programmed defrost function automatically provides the maximum defrosting of the vehicle. When the programmed defrost function is selected, the ATC module configures the control system as follows:
- Automatic mode off.
- Air inlet to fresh air, manual control.
- Selected temperature unchanged, automatic control.
- Air distribution set to screen mode, manual control.
- Blower speed set to speed 5, manual control.
- Rear screen heater and windshield heater (if applicable) selected on.
- A/C mode in automatic.
The programmed defrost function is cancelled by one of the following:
- Selecting any distribution switch. The system response will be identical to the normal manual distribution control operation.
- Selecting the automatic switch. This will restore the system to fully automatic operation.
- Selecting the programmed defrost switch again. This returns the system to the state in use immediately before the programmed defrost function was first selected.
- Turning the ignition off.
The blower speed can be adjusted manually without terminating the programmed defrost function.