Anti-Lock Brake System (Abs) Module (Vehicles With: High Performance Brakes): Installation
- Install the ABS module.
- Tighten the nuts to 8 Nm (6 lb.ft).
- Tighten the M10 and M12 unions to 15 Nm (11 lb.ft).
- Tighten the M14 union to 17 Nm (13 lb.ft).
- Connect the electrical connector.
- Secure the latch.
- Connect the battery ground cable. Refer to Specifications .
- Bleed the brake system. Refer to Brake System Bleeding - Vehicles With: High Performance Brakes .
NOTE:
Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module.
NOTE:
Make sure the ABS module locating pin is correctly located in the grommet, and the 2 isolators are fully seated in the bracket slots.