Rear Entertainment Control Module (Rem): DTCs

REAR ENTERTAINMENT CONTROL MODULE (REM) DTCs

DTC	Description	Possible Causes	Action
B1D50-79	Digital Disk Player - Mechanical linkage failure	Digital versatile disc (DVD) changer mechanical fault Error report from AiNet	Check for a mechanical fault (jammed magazine, etc). Rectify as necessary.
B1D50-93	Digital Disk Player - No operation	Digital versatile disc (DVD) changer is not responding Communication error between the main and DVD microprocessors No response from AiNet	Refer to the electrical circuit diagrams and check the AiNet circuits. Rectify as necessary.
B1D50-98	Digital Disk Player - Component or system over temperature	A high temperature condition has been detected	Check the installation of the DVD module. Make sure there is sufficient airflow. Clear the DTC and retest. Consider the atmospheric conditions before condemning a module.
B1D81-93	Rear Left Display Module - No operation	Left-hand rear display is not responding Communication error between the main and left-hand display microprocessors No response from the IS bus	Check the IS bus circuits. Refer to the electrical circuit diagrams.
B1D81-98	Rear Left Display Module - Component or system over temperature	A high temperature condition has been detected	Clear the DTC and retest. Consider the atmospheric conditions before condemning a module.
B1D82-93	Rear Right Display Module - No operation	Right-hand rear display is not responding Communication error between the main and right-hand display microprocessors No response from the IS bus	Check the IS bus circuits. Refer to the electrical circuit diagrams.
B1D82-98	Rear Right Display Module - Component or system over temperature	A high temperature condition has been detected	Clear the DTC and retest. Consider the atmospheric conditions before condemning a module.
U1A03-55	Car Config Parameter - Not configured	Rear entertainment module (REM) not configured	Where available, configure the module using the approved diagnostic system.
U1A17-31	Incomplete MOST Ring Reported By REM - No signal	No signal from the rear entertainment module (REM) Fibre optic ring break condition reported	Carry out the general media orientated system transport (MOST) test. Refer to the Network Communications instructions of the workshop information and in the approved diagnostic system, where available.