Driver Air Bag Module: Installation
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Attach the driver air bag module.
- Connect the ground cable.
- Connect the electrical connectors.
- Install the driver air bag module.
- Install top edge of module, then hinge upwards and make sure wires are connected to clips.
- Make sure the wires are not trapped behind the module.
- Hold wires in place while hinging module closed.
- Align the locating pins and springs.
WARNING:
The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
CAUTION:
Make sure the cables/harnesses are not twisted before connecting them to the airbag module. Once connected, do not rotate the air bag module as this will cause the wires to twist, which can lead to harness damage and SRS faults.
WARNING:
Driver air bag module installation can be confirmed by hearing 2 audible clicks, 1 for each spring. The module edges should also be flush with the steering wheel.