Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Install the ABS module.
Torque Specification: 10 Nm
Install the brake fluid tubes.
Torque Specification: 15 Nm
Install the battery tray support.
Torque Specifications:

M6 10 Nm

M8 25 Nm

Left-hand drive vehicles
Connect the brake booster vacuum line.
All vehicles
Install the ECM.
Secure the vacuum line and harness.
Left-hand drive vehicles
Install the windshield wiper motor and linkage.
Refer to: Windshield Wiper Motor .

Right-hand drive vehicles
Install the plenum chamber panel.
All vehicles
Install the battery tray.
Refer to: Battery Tray .
Connect the battery ground cable.
Refer to: BATTERY DISCONNECT/CONNECT .
Bleed the brake system.
Refer to: Brake System Bleeding .
If a new component has been installed, configure using Land Rover approved diagnostic equipment.