LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2011 >> LR2 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Body Closures) >> Body Closures >> General Procedures >> Liftgate Alignment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Liftgate Alignment

WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the liftgate closed, check the alignment of the liftgate to roof panel. The liftgate should be central in its aperture. Profile of the liftgate to roof panel should be 2 mm below flush.
    GJ0019667
  2. Remove the rear headliner trim panel.
    • Release the 7 clips.
    • Disconnect the electrical connector.
    GJ0014599
  3. Loosen, but do not remove both liftgate hinge to body bolts.
    GJ0014601
  4. Position the liftgate central to the aperture.
  5. Remove the LH liftgate to body bolt.
    GJ0019668
    6. CAUTION: When setting the liftgate profile, make sure that the liftgate hinge NOT being adjusted has its retaining bolt fitted.
    NOTE: Turning the Allen key clockwise will raise the liftgate.
  6. Using a 13 mm Allen key, adjust the LH liftgate hinge until a profile of 2 mm below flush to the roof panel is achieved.
    • Install the bolt and tighten to 40 Nm (30 lb.ft).
  7. Repeat the above procedure for the RH liftgate hinge.
  8. Check for correct operation of the liftgate, and if necessary adjust the liftgate and tailgate strikers.
  9. Install the rear headliner trim panel.
    • Connect the electrical connector.
    • Secure with the clips.
scientia non olet · About LEMON Manuals