Pressure Control Valve: Installation
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Install the PCV valve.
- Clean the component mating faces.
- Install the PCV valve.
- Torque: 35 Nm (26 lb.ft).
- Install the solenoid.
- Install the O-ring seal.
- Tighten to 12 Nm.
- Install the electrical connector.
- Install the new valve block filter.
- Clean the component mating faces.
- Install a new access plug O-ring seal.
- Tighten the access plug to 62 Nm (46 lb.ft).
- Remove the container.
- Remove the hose clamps.
- Secure the valve block to rear stabilizer bar actuator pipe assembly mountings.
- Tighten the nut to 9 Nm (7 lb.ft)
- Check and top-up the dynamic response system fluid reservoir.
- Start the engine and allow to idle.
- Check and top-up the dynamic response system fluid reservoir.
- Make sure there is fluid circulation through the reservoir.