Restraints Control Module (RCM): Removal

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

WARNING: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

NOTE: If the restraints control module (RCM) is to be replaced then T4 must be connected and the correct procedures adhered to, prior to battery disconnection.

NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.

Disconnect the battery ground cable. Refer to Specifications .
Make the SRS system safe. Refer to Standard Workshop Practices .
Remove the floor console. Refer to Floor Console .

CAUTION: Make sure the wiring harness is protected when cutting the carpet.

Remove the restraints control module (RCM).
- Cut the carpet for access.
- Disconnect the 2 electrical connectors.
- Remove the 3 Torx screws.