LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Front Wheel Speed Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.

    All Vehicles 

  1. Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
    2. NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.
  2. Install the wheel speed sensor.
    • Tighten the bolt to 9 Nm (7 lb.ft).
    • Connect the electrical connector.
    • Secure the wiring harness in the clips.

    3. Vehicles With Standard Brakes 

  3. Secure the brake caliper and anchor plate to the wheel knuckle.
    • Tighten the bolts to 275 Nm (203 lb.ft).

    4. Vehicles With High Performance Brakes 

  4. Secure the brake caliper to the wheel knuckle.
    • Tighten the bolts to 275 Nm (203 lb.ft).

    5. All Vehicles 

  5. Secure the wheel speed sensor lead to the brake hose retaining bracket.
  6. Install the fender splash shield. Refer to FENDER SPLASH SHIELD .
  7. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
scientia non olet · About LEMON Manuals