LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control System >> Climate Control >> Removal And Installation >> Blower Motor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Blower Motor: Installation

  1. Using the special tool, install the blower motor assembly approximately 10 degrees counter-clockwise from the vertical position.

    Remover/Installer, Blower Motor (412-140)

    GJ0021194
  2. Rotate the special tool clockwise to secure the blower motor assembly.

    Remover/Installer, Blower Motor (412-140)

    GJ0021195
  3. Install the recirculation blend door housing assembly.
    • Connect the recirculation blend door actuator electrical connector.
    • Connect the air quality sensor electrical connector.
    • Secure the wiring harness.
  5. Install the CJB bracket.

    Torque: 10 Nm

  6. Secure the wiring harnesses to the CJB bracket.
  7. Install the CJB.
  8. Connect the 5 electrical connectors to the CJB and secure the front carpet.
  9. Install the CJB lower access cover.
  10. Install the passenger side footwell duct.
  11. Install the glove compartment. Refer to GLOVE COMPARTMENT .
  12. Connect the blower motor electrical connector.
  13. Install the accelerator pedal assembly. Refer to the appropriate Accelerator Pedal information.
  14. Connect the battery ground cable. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals