LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Front Wheel Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Raise and support the vehicle.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  2. Remove the front wheel and tire.
  3. Remove the fender splash shield. For additional information, refer to Fender Splash Shield .
  4. Release the wheel speed sensor lead from the brake hose retaining bracket.
    GJ0015007

    5. Vehicles with standard brakes 

  5. Release the brake caliper anchor plate from the wheel knuckle and tie the caliper aside.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    • Remove the 2 retaining bolts.
    GJ0015008

    6. Vehicles with high performance brakes 

  6. Release the brake caliper from the wheel knuckle.
    • Remove the 2 retaining bolts.
    • Tie the brake caliper aside.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    GJ0015009

    7. All vehicles 

  7. Release the wheel speed sensor from the wheel knuckle.
    • Remove the bolt.
      NOTE: The brake disc is shown removed for clarity.
      GJ0013411
  8. Remove the wheel speed sensor.
    • Disconnect the electrical connector.
    • Release the wiring harness from the clips.
    GJ0015010
scientia non olet · About LEMON Manuals