Rear Wheel Speed Sensor: Installation
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
- Install the wheel speed sensor.
- Attach the wiring harness to the 4 clips.
- Secure the wheel speed sensor to the wheel knuckle.
- Tighten the bolt to 9 Nm (7 lb.ft).
- Attach the wiring harness to the clip.
- Connect the ABS sensor electrical connector.
- Attach the wiring harness.
NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness. - If a new wheel speed sensor has been installed, interrogate the ABS system using T4.