Dynamic Response Module: Installation
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Install the dynamic response module.
- Connect the electrical connectors.
- Tighten the 2 bolts to 4 Nm (3 lb.ft).
- Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
- Install the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel .
- Initiate a new control module using T4.