In-Vehicle Temperature Sensor - Removal And Installation: Removal
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Fully extend the steering column for access.
- Remove the instrument panel access panel.
- Release the 2 clips.
- Remove the steering column upper shroud.
- Release the 6 clips.
- Remove the steering column lower shroud.
- Remove the 3 Torx screws.
- Disconnect the electrical connector.
- Remove the instrument panel center finisher.
- Release the steering column gaiter panel.
- Remove the 2 Torx screws.
- Release the 2 clips.
- Remove the in-vehicle temperature sensor.
- Release the 2 clips.
- Disconnect the electrical connector.
- Disconnect the hose.