STOPLAMP Switch
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
The stoplamp switch is mounted in the brake pedal bracket and operated by the brake pedal. The stoplamp switch is a two pole switch: The BS (brake switch) pole supplies a brake pedal status signal to the ABS module; the BLS (brake lamp switch) pole operates the stoplamps and also supplies a brake pedal status signal to the ABS module and to the engine control module (ECM).
While the brake pedal is released:
- The BS contacts are closed, and connect an ignition power feed from the central junction box (CJB) to the anti-lock brake system (ABS) module.
- The BLS contacts are open.
When the brake pedal is pressed:
- The BS contacts open.
- The BLS contacts close, and connect an ignition power feed from the CJB to the three stoplamps, the ABS module and the ECM.
The ABS module monitors the status inputs from the stoplamp switch and broadcasts the brake pedal status and an associated quality factor on the high speed CAN bus.