'Engine Oil Level Critically LOW' Warning Message Displayed - Engine Control Module Software Update (LTB00539NAS2)
Publication date: 2013-08-21Reference number: LTB00539NAS2
'ENGINE OIL LEVEL CRITICALLY LOW' WARNING MESSAGE DISPLAYED - ENGINE CONTROL MODULE SOFTWARE UPDATE
TECHNICAL SERVICE BULLETIN
Reference Number(s): LTB00539NAS2, Date of Issue:
August 21, 2013
Superceded Bulletin(s): LTB00539NAS1
| LAND ROVER: | 2013 Range Rover (LG) |
| SECTION: | 303-14C/14D |
| AFFECTED VEHICLES: | Range Rover (LG) Model Year: 2013 VIN: DA001204-DA120121 |
NOTE:
This reissue replaces all previous versions. Please destroy all previous versions. Only refer to the electronic version of this Technical Bulletin in TOPIx.
MARKETS
NAS
CONDITION SUMMARY
Situation:
An 'Engine Oil Level Critically Low' message may be displayed in the Instrument Cluster (IC) while driving. However, when viewing the oil level in the IC Service Menu, the oil level shows as 'normal'.
NOTE:
The Engine Control Module (ECM) may also be referred to as Powertrain Control Module (PCM).
Cause: This may be caused by a software issue within the Engine Control Module (ECM).
Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below.
PARTS
No Parts Required
TOOLS
NOTE:
This document is an 'Active Bulletin' that will display a functional programming shortcut if accessed within a diagnostic session using SDD.
IDS with latest IDS-DVD and Calibration File; first available on DVD134.12 v.144
Jaguar Land Rover-approved Midtronics Vehicle Power Supply
WARRANTY
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair time.
NOTE:
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
| DESCRIPTION | SRO | TIME (HOURS) | CONDITION CODE | CAUSAL PART |
|---|---|---|---|---|
| Tune - download - engine management ECU | 12.90.13 | 0.20 | 42 | LR038618 |
NOTE:
Normal Warranty policies and procedures apply.
REPAIR PROCEDURE
CAUTION:
A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the vehicle battery during IDS/SDD diagnosis/module programming.
NOTE:
IDS must be loaded with DVD134.12 v.144 or later.
- Connect the Jaguar Land Rover-approved Midtronics battery power supply to the vehicle battery.NOTE: The Engine Control Module (ECM) may also be referred to as Powertrain Control Module (PCM).
- Turn ignition 'ON' (engine not running).
- Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
- Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle and initiating the data collect sequence.
- Select 'Diagnosis' from the Session Type screen.
- Select the 'Selected Symptoms' tab, and then select the following:
- Electrical/Instruments/Information and message center/Message display area/Powertrain
- Select 'continue'.NOTE: The Engine Control Module (ECM) may also be referred to as Powertrain Control Module (PCM).
- Select the 'Recommendations' tab, and then select 'Run' to perform the 'Configure existing module - Powertrain control module' option.
- Follow all on-screen instructions to complete this task.
- Exit the current session.
- Disconnect the IDS and the battery power supply from the vehicle.