Symptom Chart

WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.

Symptom	Possible Causes	Action
The DVD does not operate	DVD multi-changer fuse blown No power to display screens Condensation	Refer to the electrical circuit diagrams and test the DVD power circuit for short circuit to ground Refer to the electrical circuit diagrams and test the DVD player power and ground circuits for open circuit, high resistance Wait at least one hour for the condensation to dry out
Remote control operation is unstable	Handset batteries low on power Remote control receiver sensor or transmitter is dirty	Check and renew the batteries as necessary Check and clean the receiver and transmitter as necessary
There is no picture	The display screen is set to an incorrect mode	Use the switch on the back of the handset to select the correct mode.
Playback does not start	Disc is loaded upside-down An incorrect format of disc is loaded Parental lock is set The setup menu is displayed	Check that the disc is correctly loaded Check that the disc format is compatible Cancel parental lock or check the rating of the disc Press SET for at least 2 seconds to turn the setup menu off
The picture is unclear or noisy	The disc is being fast forwarded or rewound The vehicle battery power is low	The picture may be slightly distorted in fast forward or rewind modes Check the vehicle battery condition and state of charge
The image "freezes"	The disc is scratched	Load an undamaged disc.
NO MAG is displayed	There is no magazine loaded into the DVD multi-changer	Load a magazine.
NO DISC is displayed	There is no disc loaded into the magazine The disc is dirty	Load a disc into the magazine. Clean the disc as necessary.
REGIONAL CODE VIOLATION is displayed	The disc loaded does not match the regional code number	Load a disc which matches the regional code number.
VIDEO SIGNAL IS NOT CORRECT is displayed	An NTSC disc is loaded into a PAL system, or vice versa	Load a disc of the correct format.
HI TEMP is displayed	The system protective circuit is activated as it has detected a high temperature	Turn the power OFF on the unit and then back on again. If the display does not clear, leave the power off until the temperature decreases and turn the power ON again.