Front Drive HALFSHAFTS: Specifications
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
General Specification
| Item | Specification |
|---|---|
| Type | Fully floating, fixed length, solid shafts incorporating constant velocity joints at each end of shaft |
Lubricant
| Item | Specification |
|---|---|
| Outboard joint | Use grease supplied with replacement boot kit (Optimol MS139G) |
| Inboard joint | Use grease supplied with replacement boot kit (1 Luber C MS132G) |
General Specification
| Item | Specification |
| Type | Fully floating, solid shafts incorporating 'plug-in' constant velocity joint at inboard end and fixed constant velocity joint at outboard end of shaft |
Torque Specifications
| Description | Nm | lb-ft |
|---|---|---|
| * Stabilizer bar link nut | 115 | 85 |
| * Stabilizer link nut | 115 | 85 |
| * Tie rod end ball joint nut | 76 | 56 |
| Brake hose retaining bracket to wheel knuckle bolt | 25 | 18 |
| *+ Halfshaft retaining nut | 230 | 169 |
| Road wheel nuts | 140 | 103 |
* New nut must be fitted
+ Stake nut on completion