Auxiliary Blower Motor Control Module: Installation
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Install the resistor.
- Tighten the screws.
- Connect and secure the electrical connector.
- Install the C-pillar lower trim panel. Refer to C-Pillar Lower Trim Panel article.
- Connect the battery ground cable. Refer to Specifications article.
NOTE:
Align to the position noted on removal.