Removal And Installation: Installation

Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.

Install the wheel speed sensor.
- Connect the electrical connector.
- Attach the wiring harness to the 5 clips.
- Tighten the bolt to 9 Nm (7 lb.ft).
Secure the brake caliper and anchor plate to the wheel knuckle.
- Tighten the bolts to 275 Nm (203 lb.ft).
Secure the brake hose retaining bracket to the wheel knuckle.
- Tighten the bolt to 25 Nm (18 lb.ft).
Install the fender splash shield.
For additional information, refer to: Fender Splash Shield .
Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
If a new wheel speed sensor has been installed, interrogate the ABS system using T4.