DTC U3000-49: Control Module - Internal electronic failure: Action

NOTE: Make sure there is no movement of the ground stud from the relative body panel. Make sure the ground electrical connectors are clean, flat and securely clamped to the stud

Refer to the electrical circuit diagrams and check the anti-lock brake system hydraulic control unit pump ground circuit for open circuit, high resistance. Repair the circuit as required
Refer to the electrical circuit diagrams and check the polarity of the left and right motor. Repair the circuit(s) as required
Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the Diagnostic Trouble Code(s) and retest. If the fault persists, install a new anti-lock brake system control module as required